Several RM-Primis functions need to know what the driver is doing: whether the clutch is pressed for launch control, whether the brake is on, whether traction control should be switched off for a burnout, or whether the kill switch has been pulled. The Special functions page is where each of these switches is given an input. Any digital input, or an analog input used as a switch, can be used.
This page explains each function, how to wire and learn its input, and how to check it works.
Open I/O → Inputs & outputs → Special functions (see the menu on the Radiator fan and air conditioning page).
Each function has a row: the Input it uses, its Edge, the Voltage on the input now, the Learned voltage of an analog input, its State and the Learn button.
| Function | What it does |
|---|---|
| Kill switch | Shuts the engine down: ignition and injection. It can be a switch, or a pulse that keeps the engine off until the next power cycle |
| Traction override | Switches traction control off while active, for burnouts or the dyno. See Traction control |
| Clutch switch | Tells the ECU the clutch is pressed. Used by launch control and flat shift and by anti-lag's clutch activation |
| Brake switch | Tells the ECU the brake is pressed, for the functions and gearboxes that need it |
| Hand brake | While active, the road speed stops updating, which helps when drifting: functions that use the road speed do not react to the locked rear wheels |
| Gearbox controls (BMW 8HP) | Paddle up and down, the 8HP drive modes, and the 8HP Performance Package's transbrake, bump and virtual clutch inputs. They appear once the CAN transmission is set to BMW 8HP and its shifter is chosen. See ZF 8HP over CAN and Paddle shifters |
A switch on a digital input is on or off. Edge sets which way round: Rising for a switch that reads high when active, Falling for one that reads low. If the State column shows the opposite of what the switch is doing, change the edge.
A switch on an analog input works too, which is useful when the digital inputs are all used. Wire the switch so it pulls the input to a known voltage when active, hold it active and press Learn: the ECU stores the voltage, shown under Learned, and from then on counts the input as active when it reads that voltage. In the picture, the brake switch is on the analog input Spare 4 and was learned at 4.69 V.
On an analog input, keep each function's voltage well apart from any other function sharing the same input, at least 0.31 V. Several buttons can share one analog input through a resistor ladder, each at its own voltage.
Yes. Choose it for the function, hold the switch active and press Learn. The ECU recognises that voltage as the switch being on.
The Clutch switch. Launch control, flat shift and anti-lag's clutch activation all read it.
The ECU stops the ignition and injection. With a pulse-type kill switch the engine stays off until the ECU is next switched off and on.
Contact customer support at [email protected].
Related pages: Launch control and flat shift · Traction control · Trigger inputs · Analog inputs