An oil pressure sensor, a fuel pressure sensor, an oil temperature sender: the more an engine is pushed, the more it pays to watch. The RM-Primis has four configurable analog inputs that turn any 0–5 V sensor into a reading the ECU can log, show and broadcast, and, more importantly, use to protect the engine. Oil pressure that falls below what the engine needs at that speed can cut the engine before the bearings are gone.
This page explains how an analog input is calibrated, how its protection works, and walks through an oil pressure protection from start to finish.
Ecu function tells the ECU what the input measures (AFR, fuel pressure, fuel temperature, oil pressure or oil temperature), so it is logged and broadcast as that.
Each input has two pages under I/O → Inputs & outputs: Analog input 1 (its settings) and Analog input 1 tables (its calibration and target), and the same for inputs 2 to 4 (see the menu on the Radiator fan and air conditioning page).
| Setting | What it does |
|---|---|
| Analog input pin | The ECU input the sensor is wired to |
| Ecu function | What the input measures, for logging and broadcasting |
| Enable analog input | Switches the input on. Switch the ECU off and on afterwards: an input starts or stops reading at start-up |
| Disable injection when triggered | Cuts the injection while the protection is triggered |
| Disable inj. and ign. when triggered | Cuts the injection and the ignition while the protection is triggered |
| Max. Value. / Min. Value. | The sensor's valid voltage range. Outside it the input reports a fault |
| Fault value | The value used while the sensor is faulty |
| Threshold | Hysteresis on the protection, in the calibrated units |
| Input filter | Smooths the reading. More filtering is steadier but slower |
The Live values panel shows whether the input is active, whether it is triggered, the voltage and the calibrated value.
The calibration converts the voltage into your units. The example is a common 0–10 bar pressure sensor with a 0.5–4.5 V output: 0.5 V is 0 bar and every volt above it adds 2.5 bar. Take the figures from the sensor's data sheet; Quick cal fills the table from a few points.
The target is the limit, by Table source: engine speed, load, MAP, coolant, air temperature or the air flow (MAF) the ECU works out. Trigger when decides which side of it triggers the protection. The example asks for at least 0.8 bar at 1000 rpm, rising to 3.2 bar at 6500 rpm, and triggers when the oil pressure is less than that.
Set the target with a margin below the engine's normal oil pressure. Oil pressure dips briefly in long, fast corners on a wet sump: a target set too close to normal will cut the engine in the middle of a corner.
Any sensor with a 0–5 V output: pressure sensors for oil, fuel or boost, temperature senders with a pull-up, position sensors, or a switch used as an input.
The voltage goes outside Min. Value. to Max. Value., the input reports a fault and uses Fault value, and its protection is suspended, so a broken wire does not stop the engine.
Yes: each analog input's value is in the datalog and the live values.
Contact customer support at [email protected].
Related pages: Special functions · Engine protection · Generic PWM outputs · Wiring diagram