Most engines that fail under boost fail in one of two ways: the mixture goes lean (a tired fuel pump, a blocked filter, an empty tank in a long corner) or the boost goes too high (a split wastegate hose, a stuck solenoid, a gate that cannot open). Either can melt a piston in seconds, long before the driver notices. The RM-Primis watches for both and cuts the injection the moment it sees them, so the engine stops making power before it hurts itself.
This page explains how lean protection and overboost protection work and how to set them so they catch a real fault without stopping the car for nothing.
Both protections work the same way:
Open Safety → Limits & protections → Lean protection and Overboost (see the menu on the Rev limiter page).
| Setting | What it does |
|---|---|
| Enable Lean protection | Switches lean protection on |
| Alarms above | The manifold pressure above which the mixture is checked. Below it, at idle and cruise, where lean mixtures are normal and harmless, nothing is checked |
| AFR limit | A mixture leaner than this, with the protection armed, counts against the engine |
| Sensitivity | How quickly the protection trips: a higher value cuts sooner |
How to set it. Arm it where the engine makes real power: on a turbo engine just above atmospheric pressure (110–130 kPa), on a naturally aspirated engine near full load (90–95 kPa). Set the AFR limit clearly leaner than your full-load target but still safe: with a target of 11.8:1 on gasoline, 13.0–13.2:1 is a good limit. Start with a moderate Sensitivity and check it does not trip on the brief lean spike of a gear change.
Lean protection relies on the wideband sensor. Make sure it is warm and reading correctly (Wideband sensor), and that the AFR limit suits your fuel: on E85 the same lambda is a much richer AFR.
| Setting | What it does |
|---|---|
| Enable Overboost protection | Switches overboost protection on |
| Boost limit | The manifold pressure, in kPa absolute, above which the protection starts counting |
| Sensitivity | How quickly the protection trips: a higher value cuts sooner |
How to set it. Set the Boost limit 10–20 kPa above the highest target on the boost table: high enough that a normal spike as the turbo spools does not trip it, low enough to stop a runaway. With a 235 kPa target, 250 kPa is a good limit. It also protects an engine without boost control, against a wastegate that sticks shut.
Never test a protection by making the engine run lean or overboost on purpose. Instead:
The ECU cuts all injection, logs a fault code and shows the protection as active. The engine makes no power until the driver lifts off or the engine drops below 1500 rpm; then the fuel returns.
Each protection adds up how far and how long the reading is beyond its limit, so a brief flicker or a sensor glitch does not cut the engine. Sensitivity sets how quickly the total trips it.
No. Boost control holds the boost you want; overboost protection is the safety net if boost control fails. Use both.
Contact customer support at [email protected].
Related pages: Boost control · Wideband sensor · Rev limiter · Knock control