On a standalone ECU the cooling fans and the air conditioning compressor are the ECU's job. Done well, the fan switches on before the engine runs hot and the idle never dips when it does; the A/C compressor engages smoothly at idle and drops out at full throttle so the engine gets all its power. The RM-Primis controls two fans and the A/C compressor, and raises the idle for each of them.
This page explains how fan and A/C control work, how to set them up, and how to make them invisible to the driver.
Open I/O → Inputs & outputs → Radiator fan and Air conditioner.
Each fan follows a Control Reference, normally the coolant temperature. It switches on when the reference rises Output hysteresis above the FAN setpoint and off again when it falls the same amount below it. The gap stops the fan clicking on and off around one temperature.
A fan is a big electrical load: switching it on drops the idle. So the ECU first opens the idle valve by Idle-up adder and then switches the fan on, after part of the Idle-up time before turn ON. The extra opening then fades away over that time, by when the idle control has caught up. Fan control starts two seconds after the engine starts.
The Secondary fan works the same way with its own settings: use it for a second fan, or a second speed of the same fan, that comes on a few degrees later.
| Setting | What it does |
|---|---|
| Fan output | The output that drives the fan relay. Make sure nothing else uses it |
| Control Reference | What the fan follows: CLT (coolant), IAT, TPS, MAP, RPM or Speed |
| FAN setpoint | The temperature (or value) the fan works around |
| Output hysteresis | The fan switches on this far above the setpoint and off this far below it |
| Idle-up adder | The extra idle opening given as the fan switches on |
| Idle-up time before turn ON | How long the idle is raised around the fan switching on, in ms |
When the driver asks for A/C (a request input, or the request over CAN from the car's climate control), the ECU engages the compressor clutch, but only while:
As the compressor engages, the idle opening is raised by Idle-up adder in the same moment, and taken off when it drops out.
| Setting | What it does |
|---|---|
| Request input | The input that asks for A/C. Leave it Disabled to take the request over CAN. Learn sets the switching point of an analog input used as a switch |
| Compressor output | The output that drives the compressor clutch relay |
| CAN PWM override | For VW and Audi cars whose climate control asks for a fan speed over CAN: the ECU drives the chosen generic PWM fan at whichever is higher, its own table or the CAN request |
| Maximum CLT | The compressor drops out above this coolant temperature |
| Minimum RPM / Maximum RPM | The compressor drops out below or above these engine speeds |
| Maximum Load and Load hysteresis | The compressor drops out above this load, so full throttle gets full power |
| Idle-up adder | The extra idle opening while the compressor is engaged |
| Turn on delay | The least time the compressor stays off before it may engage again, against short cycling |
Raise the idle Target RPM if your engine idles too slowly to drive the compressor smoothly. See Idle control.
The fan's electrical load drags the engine down. Raise the fan's Idle-up adder so the idle valve opens as the fan starts, and check idle ignition control is on.
Yes: the Control Reference can be the coolant, the intake air temperature, the throttle, the manifold pressure, the engine speed or the road speed. An intercooler fan, for example, can follow the intake air temperature.
So the engine gets all its power: above Maximum Load the compressor drops out, and comes back as soon as the load falls.
Contact customer support at [email protected].
Related pages: Idle control · Programmable outputs · Generic PWM outputs · Coolant and air temperature sensors