BMW's SMG II, the automated manual gearbox of the E46 M3 and the Z4, changes gear with hydraulics, but it relies on the engine computer for half of every shift: cutting the torque as the clutch opens, holding the engine at the right speed while the clutch is out, and blipping the throttle on downshifts. The RM-Primis does all of that over the engine CAN bus, so an SMG car keeps fast, smooth, factory-like shifts with a standalone ECU, and gains a tuneable rev match and a Sport mode that stays where you leave it.
This page explains what the ECU does during each shift and how to set it up and tune it.
The ECU reads the gearbox's state from the CAN bus: the gear, the shift in progress, the clutch, the torque the gearbox asks for and its warning lamp. During each shift it does what the original engine computer did:
Upshifts.
Downshifts.
Each gear's engine speed comes from the gear ratios the ECU learns on Gear settings, so set those up first.
| Setting | What it does |
|---|---|
| Driving mode | The SMG's Sport mode, which the car's Sport button used to select. Sport: the gearbox, the steering and the instrument cluster take their sport settings. Normal: sport off. The choice is kept in the tune, so it stays after the ignition is switched off (the original button went back to Normal at every key-on). It does not change the ECU's own pedal or throttle maps |
| Sport by DSC button | Hold the DSC button until the DSC switches fully off (the DSC and brake lamps light, after about 2.5 s), and the driving mode swaps between Normal and Sport. A short press, which only switches off the stability control, does not swap. The swap lasts until the ignition is switched off |
Related options elsewhere:
Upshifts. Log the engine speed, the gear and the torque intervention over a few full-throttle upshifts.
| What happens | What to change |
|---|---|
| The engine flares on the upshift | Check the gear ratios are learned; check the torque intervention method |
| The upshift feels slow or soft | Keep Close ETB on upshifts at No |
| A jolt as the clutch takes up | Check the torque tables match the engine's real torque |
Downshifts. The Throttle rev match table alone decides how hard each match climbs. Log the engine speed and the target speed through a few downshifts at different road speeds:
| What happens | What to change |
|---|---|
| The engine arrives below the lower gear's speed (the car jerks back) | Raise the Throttle rev match cells at that engine speed |
| The engine overshoots and the car lurches forward | Lower those cells |
| The car lurches on downshifts while braking to a stop | Raise No blip below |
A worked example. On an E46 M3, downshifting from 3rd to 2nd at 60 km/h needs about 4500 rpm. The log shows the engine reaching only 4100 rpm before the clutch closes. Raising the rev match cells around 4300–4800 rpm by a few percent brings it to 4450–4550 rpm, and the downshift lands smoothly.
Yes. The RM-Primis does the engine computer's part of every shift over the CAN bus: torque cut on upshifts, holding the engine speed while the clutch is open, and throttle blips on downshifts.
For the downshift blips: the ECU opens the throttle to raise the engine speed for the lower gear. With a cable throttle it cannot.
Yes: set Driving mode to Sport. It is kept in the tune and comes back at every key-on.
Contact customer support at [email protected].
Related pages: Torque tables · Gear settings · CAN bus setup · Electronic throttle · Traction control