When you lift off the throttle and the car drives the engine, coasting down a hill or slowing for a corner, the engine needs no fuel at all: the wheels keep it turning. Overrun fuel cut, also called deceleration fuel cut-off (DFCO), switches the injectors off in those moments. It saves fuel, stops the unburnt mixture that would otherwise pop in the exhaust, keeps the catalyst cool and adds engine braking.
This page explains when the RM-Primis cuts the fuel, when it brings it back, and how to set it so the engine never stumbles or stalls as the fuel returns.
The ECU cuts all injection when all of these are true:
The fuel comes back as soon as one of them stops being true: normally when the engine slows to Engine speed above on the way down to idle, or when the driver touches the pedal. A small hysteresis on the engine speed and the manifold pressure stops it switching on and off at the edges.
If the idle control uses a Request input (an idle switch), overrun fuel cut waits for that input instead of the pedal threshold. An input that never switches on means overrun fuel cut never happens. See Idle control.
Open Safety → Limits & protections → Overrun fuel cut (see the menu on the Rev limiter page).
| Setting | What it does |
|---|---|
| Overrun Fuel cut | Switches overrun fuel cut on |
| When in sport turn off | With a gearbox that has a sport mode (BMW SMG, ZF 8HP, the E36/E46 automatic): no overrun fuel cut while it is in a sport mode, so the engine stays fuelled for crisper throttle response and the sound on the overrun |
| Engine speed above | The engine must be above this speed. The fuel returns below it |
| CLT above | The coolant temperature needed before the fuel may be cut |
| Pedal less than | The pedal (or throttle) must be below this |
| MAP less than | The manifold pressure must be below this, so the fuel is only cut with the throttle closed and the engine pulling a deep vacuum |
| What happens | What to change |
|---|---|
| The engine stumbles or stalls as it comes down to idle | Raise Engine speed above, so the fuel returns earlier; set the idle valve's return with Set output when no request and Smooth idle on Idle control |
| A jolt as the fuel returns | Raise Engine speed above; check the fuel table's low-load cells are not too lean |
| The fuel is never cut | CLT above, MAP less than (check the overrun MAP in a log), Pedal less than against the pedal's resting reading, and the idle Request input |
| Pops and bangs on the overrun | The fuel is not being cut, or returns too often: check the conditions above |
| The lambda reads very lean on the overrun | Normal: with no fuel the sensor sees pure air |
Another name for overrun fuel cut: the injectors are switched off while the car drives the engine with the throttle closed, and switched back on near idle or when the driver presses the pedal.
No, it stops them. Pops on the overrun come from fuel burning in the exhaust; with the injectors off there is no fuel to burn.
With the fuel cut, the engine pumps pure air through the exhaust, and the wideband reads it as extremely lean. That is expected.
Contact customer support at [email protected].
Related pages: Idle control · Rev limiter · Fuelling settings · Wideband sensor