The ignition table is tuned on a warm engine breathing air at a normal temperature. Two temperatures change how much advance the engine wants after that, and the RM-Primis ECU corrects the timing for both:
Each correction is a curve in degrees: the ECU reads the temperature, takes the correction from the curve and adds it to the advance from the ignition table. Positive values advance the timing, negative values retard it, and 0 leaves it as it is.
Open Tune → Ignition → Coolant / IAT compensation. The page has two curves on tabs, Ignition vs coolant and Ignition vs air temp, with the live temperatures and corrections beside them. The table tools are described on the Fuel table page.
A typical curve adds 4–6° at -40 °C, tapering to 0 by 30–40 °C, and stays at 0 at working temperature.
| Live values | Temperature and Compensation: the coolant temperature now and the degrees being added |
| Disable | Under the curve: switches the correction off, to tune or test without it |
Tuning it. On a cold start, once the engine is running: if it idles roughly and responds lazily until it is warm, a degree or two more at those temperatures helps. If it pings or kicks back while cold, take some away. Keep the curve at 0 from about 40 °C up, so it never changes the warm engine's timing.
A typical curve is 0 from about 0 to 40 °C, retards progressively above 50–60 °C (about -2° at 80 °C and -6° at 100 °C) and adds a degree or two in very cold air. Turbocharged and high-compression engines need it most.
Tuning it. The curve's job is to keep the knock margin you tuned on a normal day. Look at your logs for the hottest intake air the car sees: after a long idle in traffic, after repeated full-throttle runs, on the hottest day. If the knock control reacts at those temperatures, add retard there. Tune the ignition table at a normal air temperature first, so the curve only covers the difference.
Retarding for hot air protects the engine, but it is no substitute for knock control and an intercooler that works: check the air temperature in your logs on a hot day, under load.
A few degrees, yes: cold mixtures burn slowly, so extra advance gives a smoother idle and better response while warming up. Bring it back to 0 well before working temperature.
Retard more at high air temperatures on the Ignition vs air temp curve, and check the mixture is not lean when hot. If the air temperature climbs under boost, look at the intercooler.
Contact customer support at [email protected].
Related pages: Ignition table · Coolant and air temperature fuel trims · CLT and IAT sensor calibration