Your fuel table is tuned on a warm engine, on the day you tuned it. Two temperatures change what the engine needs after that: the coolant temperature (CLT), which tells the ECU how warm the engine is, and the intake air temperature (IAT), which changes how dense the air is and how well the fuel evaporates. The RM-Primis ECU corrects the fuel for both, so the engine runs the same on a cold morning and a hot afternoon.
Each correction is a curve of percentages. The ECU reads the current temperature, takes the percentage from the curve and adds it to the fuel: positive values add fuel, negative values remove it, 0 % leaves it as it is.
Coolant. A cold engine wastes fuel: it condenses on cold ports and cylinder walls instead of burning. Until the engine is warm, it needs extra fuel all the time, not only during the start. The coolant curve supplies that extra, fading to nothing at working temperature. It works alongside the cold start and warm-up enrichments, which handle the first seconds and minutes.
Intake air. Speed density already allows for the air's density from its temperature, so the air temperature curve is a fine correction, for what the density calculation does not capture: fuel evaporating better in warm air, heat soak in the manifold, an engine that simply runs a little lean on cold days. Many engines run well with it at 0 % everywhere.
Open Tune → Fuel → Coolant / IAT compensation. The page has two curves on tabs, coolant and intake air, each with the live temperature and correction beside it. The table tools are described on the Fuel table page.
| Table | The fuel correction in % at each coolant temperature |
| Live values | Temperature, the coolant temperature now, and Compensation, the correction the ECU is adding at that temperature |
A typical curve adds 15–25 % at -40 °C, a few percent at 50–60 °C, and reaches 0 % at the engine's normal working temperature, usually 80–90 °C. Above that, a small negative value can be used if the engine runs rich when very hot.
Tuning it. Tune it as the engine warms up, after the start tables:
Use it if your logs show the mixture drifting with air temperature:
Tuning it. Compare logs from the same drive in different weather, or before and after heat soak. If the fuel table is right at 25 °C intake air and the engine reads 3 % rich at 55 °C, take about 3 % off at 55 °C. A few percent at either end is normal; large corrections usually mean the air temperature sensor sits somewhere it reads the wrong air (see CLT and IAT sensor calibration).
The idle control also uses this correction: in open loop, it moves the idle valve by twice the value, the other way. A -5 % correction opens the idle valve 10 % more, to keep the idle speed up in hot air.
Both corrections can be switched off under Compensation disable on Fuelling settings, so you can tune the fuel table on a warm engine without them. Switch them back on afterwards.
The coolant correction adds a percentage of fuel; in the first minutes the engine also needs the start and warm-up enrichments. Check those first, then add coolant correction at the temperatures where it is still lean once running.
Often, yes. Speed density already accounts for air density. Use the IAT curve only to correct a drift you can see in your logs.
Contact customer support at [email protected].
Related pages: Cold start and warm-up enrichment · Fuelling settings · CLT and IAT ignition corrections · CLT and IAT sensor calibration