Honda's VTEC gives the engine two camshaft profiles on the same shaft: a mild one for low speeds and a wild, high-lift one for the top end. An oil-pressure solenoid locks the rocker arms onto the high-lift lobe when the ECU says so. Engage it too early and the engine loses torque in the mid-range; too late and it runs out of breath before the switch. The RM-Primis lets you choose exactly where VTEC engages and disengages, and it can swap the fuel, ignition and other tables to a second set made for the high cam.
This page explains how the RM-Primis controls VTEC, how to set it up and how to find the best crossover point on the dyno.
The ECU switches the VTEC Output (the VTEC solenoid) on when both of these are true:
and the coolant has reached CLT Minimum, so the oil is warm enough to move the rocker pins cleanly.
It switches the solenoid off again only when both the engine speed and the load have fallen below the OFF at points. Keeping the OFF points a little below the ON points gives the switch hysteresis, so the solenoid does not chatter when the engine sits right at the crossover.
Table switch. While VTEC is on, the tables you tick under Table switch change to their secondary set. The high cam fills the cylinders differently, so it usually needs its own fuel table and often its own ignition timing. The secondary tables are edited on the same pages as the primary ones (choose Secondary in the table set list) and are described on the Table switch page.
Open Tune → Variable valve timing → VTEC (see the menu on the VVT page).
| Setting | What it does |
|---|---|
| VTEC Output | The ECU output that drives the VTEC solenoid |
| CLT Minimum | VTEC stays off below this coolant temperature |
| VTEC status | Whether VTEC is on now |
| ON at: RPM and MAP | VTEC switches on when the engine speed and the load are both at or above these |
| OFF at: RPM and MAP | VTEC switches off when the engine speed and the load are both below these. Keep them below the ON points |
| Table switch | The tables that change to their secondary set while VTEC is on: Fuel, Target lambda (AFR), Ignition, Intake VVT, Exhaust VVT and Boost |
In the example VTEC engages at 5500 rpm with at least 70 kPa in the manifold, disengages below 5200 rpm and 60 kPa, waits for 60 °C of coolant, and swaps the fuel and ignition tables while it is on.
The best place to switch is where the two cam profiles make the same torque. Below it the low cam makes more; above it the high cam does.
A dip or a flat spot right after the switch means the secondary tables need work at that speed (usually fuel), or the crossover is too early.
Where the torque curves of the two cam profiles cross, which you find on the dyno (section 5). On a modified engine it is often different from the factory point: new cams, intake or exhaust move it.
So it only engages under load. At light load the high cam brings no benefit, and switching it in while cruising at high revs would only make the engine less smooth and less efficient.
Yes: tick Fuel and Ignition under Table switch and the ECU uses the secondary tables while VTEC is on.
Contact customer support at [email protected].
Related pages: Table switch · Intake and exhaust VVT · Fuel table · Ignition table