An injector does not open and close instantly. Over most of its range that does not matter: twice the pulse gives twice the fuel, and the dead time takes care of the opening delay. But with very short pulses, a millisecond or less, the needle has barely lifted before it closes again, and the fuel delivered stops following the pulse in a straight line. Big injectors make it worse: a 1000 cc/min injector idling on a small engine may run pulses of only 0.6 ms, right in its unpredictable zone.
Small pulse width compensation corrects that, so the engine gets the fuel the calculation asks for even with the shortest pulses. This page explains what it does and how to set it.
The table maps the pulse the fuel calculation asks for (Pulse Width, across) to the pulse the ECU actually sends to the injector (PW out). Where the two are equal, nothing changes. Where the injector delivers less fuel than it should for a short pulse, the table sends a slightly longer one; where it delivers more, a shorter one.
The table covers the shortest pulses only, up to about 2 ms; above that the injector is linear and the pulse passes through unchanged.
Open Tune → Fuel → Small pulse width compensation.
In the example, a requested 0.143 ms becomes 0.200 ms and 0.429 ms becomes 0.480 ms, while pulses from about 1.7 ms up pass through unchanged. The Live values panel shows the Static pulse width (what the calculation asks for) and the Output pulse width (what the injector gets).
Quick cal. fills the table from a few points you enter, interpolating between them: a quick way to put in an injector maker's small pulse data.
Do not use this table to tune the idle mixture. If the idle is rich or lean but stable, correct the fuel table. Small pulse compensation is for an injector's non-linear behaviour only.
Usually only with large injectors on an engine that idles with very short pulses, typically below 1–1.5 ms. With injectors sized close to the engine's needs, the default linear table works well.
How closely the fuel delivered follows the pulse width. A perfectly linear injector delivers twice the fuel for twice the pulse. Real injectors are linear above about 1–1.5 ms and less predictable below it.
Contact customer support at [email protected].
Related pages: Injector dead time · Fuelling settings · Fuel table · Staged injection