When the RM-Primis ECU switches an injector on, the injector does not open straight away. The coil inside has to build up a magnetic field strong enough to lift the needle against its spring and the fuel pressure, and until it does, no fuel flows. That delay is the injector dead time (also called latency or offset). The ECU adds it to every injection, so that the injector is flowing for exactly the time the fuel calculation asked for.
The dead time depends on the battery voltage: the lower the voltage, the slower the coil builds up, and the longer the injector takes to open. So the ECU takes the dead time from a curve by battery voltage.
The dead time error is the same size on every injection, so it matters most where the injections are short.
An example. At idle, the fuel calculation asks for 1.0 ms of fuel. If the true dead time is 0.60 ms but the curve says 0.50 ms, the injector really flows for 0.9 ms instead of 1.0: the engine runs 10 % lean. At full load, asking for 10 ms, the same 0.1 ms error is only 1 %. A wrong dead time therefore shows up as:
Get the dead time right before you tune the low-load fuel table, or you will tune the error into it.
Open Tune → Fuel → Injector dead time.
| Table | The dead time in milliseconds at each battery voltage |
| Table graph | The same curve as a line: it should fall smoothly as the voltage rises |
| Live values | Voltage, the battery voltage the ECU measures now, and Dead time, the dead time it is adding at that voltage |
| Quick cal. | In Injector dead time settings under the table: fills the curve from a list of injectors |
The table tools are described on the Fuel table page.
Dead times change with fuel pressure: the higher the pressure, the harder the needle is to lift. Use the maker's figures for the pressure your fuel system actually runs at.
The voltage test shows whether the dead time is right without any instruments beyond your wideband sensor:
| What the mixture does as the voltage falls | What it means | What to change |
|---|---|---|
| Stays the same | The dead time is right | Nothing |
| Goes lean | The real dead time at low voltage is longer than the curve says | Raise the low-voltage end of the curve |
| Goes rich | The curve's dead time at low voltage is too long | Lower the low-voltage end |
Change the curve in small steps: at idle, a few hundredths of a millisecond are a noticeable change. Then check the idle mixture with the fuel table, since the idle cells may have been tuned around the old error.
The delay between the ECU switching an injector on and the injector actually starting to flow fuel. It is longer at low battery voltage, so the ECU adds a voltage-dependent dead time to every injection.
From the injector maker's data sheet, usually as a table of offset against battery voltage at a given fuel pressure. Quick cal. has a list of injectors already in it, and you can add your own.
The Injector flow rate on Fuelling settings and the dead time curve on this page. With both right, your fuel table stays valid; check the idle afterwards.
Contact customer support at [email protected].
Related pages: Fuelling settings · Fuel table (VE) · Ignition coil dwell