Dwell is how long the RM-Primis ECU charges an ignition coil before it fires the spark. An ignition coil works like a spring being wound up: while the ECU switches current through it, the current builds up and stores energy in the coil's magnetic field. When the ECU switches it off at the moment of ignition, the field collapses and the stored energy jumps the plug gap as the spark.
The current does not build up instantly, and how fast it builds depends on the battery voltage: at 14 V a coil may be fully charged in 2 ms, at 9 V while cranking it may need 3 ms or more. So the ECU takes the dwell from a curve by battery voltage, to charge the coil fully whatever the voltage, and no longer than that.
| Dwell | Result |
|---|---|
| Too short | A weak spark: misfires under load and at high engine speed |
| Right | A full-strength spark, with the coil and ECU kept cool |
| Too long | The coil overheats; its plastic can melt and the ECU's ignition outputs can be damaged |
Open Tune → Ignition → Voltage compensation.
| Table | The dwell in milliseconds at each battery voltage |
| Table graph | The same curve as a line: longer dwell at low voltage, shorter at high voltage |
| Live values | Voltage, the battery voltage now, and Dwell time, the dwell the ECU is using at that voltage |
| Quick cal. | In Voltage compensation settings under the curve: fills the curve from a list of known coils, or from two known points of dwell and voltage |
The table tools are described on the Fuel table page.
Once a coil is fully charged, more dwell gives no bigger spark: the extra current only turns into heat, in the coil and in the ECU's ignition output. The aim is the shortest dwell that charges the coil fully at every voltage.
Never guess a long dwell to "make a bigger spark". Over-dwelling heats the coils and the ECU's outputs, and can destroy both. Use your coil maker's figures.
Dwell is a time, but a coil fires once per engine cycle (twice with wasted spark), and the cycle gets shorter as the engine speeds up. So at high speed the charging time eats into the time the coil has to cool:
| Engine | Time between sparks on one coil at 7000 rpm | 3 ms dwell is |
|---|---|---|
| Coil on plug (one spark per cycle) | 17 ms | 18 % of the time charging |
| Wasted spark (one spark per revolution) | 8.6 ms | 35 % of the time charging |
That is why wasted-spark coils and their drivers run hotter, and why a dwell that is fine at 4000 rpm can make a coil overheat in long full-throttle runs. Use the coil maker's figure, not a longer one.
Coils with and without a built-in driver. Most modern coil-on-plug coils have their own igniter: the ECU only sends a logic signal, and the coil's electronics switch the current. Older coils without one are switched by the ECU's ignition output directly and draw their full current through it. Check which yours are and use the matching dwell: a coil without a driver usually needs a longer dwell. See the ignition wiring page for how each kind is connected.
The time the ECU charges the ignition coil before each spark, in milliseconds. It decides how much energy the spark has.
A coil charges faster at higher voltage, so it needs less time to reach full charge. At low voltage, during cranking for example, it needs longer.
Contact customer support at [email protected].
Related pages: Ignition table · Injector dead time · Engine configuration