With sequential injection, each injector fires once per engine cycle, and the ECU decides when in the cycle it fires. That timing changes how well the fuel mixes with the air. Spray onto a closed, hot intake valve and the fuel evaporates before it is drawn in, which gives a smooth idle and clean emissions. Spray while the valve is open and the fuel goes straight into the cylinder, cooling the charge but wetting the walls. The Injection angle table lets you choose, for every engine speed and load.
This page explains how the RM-Primis times the injection, how to read the table and how to find the best angle on your engine.
The RM-Primis times the end of each injection. The pulse length comes from the fuel calculation, so the ECU starts the injector that much earlier, and the fuel always finishes arriving at the angle you set, however long the pulse is.
Reading the table. The table holds the end of injection in degrees before the compression stroke starts (before bottom dead centre at the end of the intake stroke). On a four-stroke engine, add 180° to get the angle before firing top dead centre:
| Table value | End of injection, before firing TDC | Where that is in the cycle |
|---|---|---|
| 0 | 180° | The end of the intake stroke |
| 90 | 270° | The middle of the intake stroke: the intake valve is open |
| 180 | 360° | The start of the intake stroke (overlap TDC) |
| 270 | 450° | The middle of the exhaust stroke: the intake valve is closed |
On a two-stroke engine add 90° instead, and on a rotary 270°.
Injection timing only matters with sequential injection, which needs a cam signal so the ECU knows which stroke each cylinder is on. See Crank and cam sensors.
Open Tune → Fuel → Fuelling settings → Injection angle (see the menu on the Fuelling settings page).
The example ends the injection between 60° and 120° before the compression stroke (240–300° before firing TDC), during the intake stroke. It ends earlier at low speed and load and later at high speed and full load, where the long pulses need every degree of the cycle.
Closed valve or open valve.
| Closed-valve injection | Open-valve injection | |
|---|---|---|
| When | Ends before the intake valve opens (table values around 200–270) | Ends while the intake valve is open (table values around 0–150) |
| Good for | Idle quality, cold starts, emissions, smooth light-load running | Full load, where the cool fuel spray lowers the charge temperature |
| Watch for | Long pulses at high speed may not fit in the closed-valve period | Fuel on the cylinder walls: richer readings, oil dilution, a rough idle |
Finding the best angle. At a steady speed and load (on a dyno, or holding a steady cruise), with the fuel closed loop off:
At idle the difference is often easy to see: a good angle gives a steadier idle and a lower idle opening for the same speed. At full load, judge on torque.
Change the injection angle in small areas and keep the table smooth. A big step between neighbouring cells makes the mixture jump as the engine passes from one to the other.
There is no single answer: it depends on the port, the injector's spray and the cams. Closed-valve injection (ending before the intake valve opens) usually gives the best idle and light-load running; ending during the intake stroke often works well at full load. Find it on your engine as in section 3.
Because the pulse length changes all the time. Fixing the end means the fuel always finishes arriving at the same point in the cycle, whatever the load.
Much less. With batch or wasted injection the injectors fire more than once per cycle, so the fuel is spread across the cycle anyway. Injection timing is a sequential-injection tool.
Contact customer support at [email protected].
Related pages: Fuelling settings · Fuel table · Injector dead time · Engine configuration