Every cylinder of an engine is a little different. The cylinders at the ends of the block run cooler than the ones in the middle; one may get a little more or less air from the intake manifold; one may be the first to knock. Spark trim lets you move the ignition timing of each cylinder on its own, on top of the ignition table, so every cylinder runs at its own best timing instead of the compromise that suits the worst one.
This page explains how spark trim works, how to read the per-cylinder RPM offset beside it, and when to use it.
Each cylinder's trim, in degrees, is added to the timing the ECU has worked out for all cylinders (the ignition table with all its corrections). A negative trim retards that cylinder, a positive one advances it. Enable switches all the trims on or off together, so you can compare the engine with and without them.
RPM offset. Beside the trims, the live values show each cylinder's RPM offset: how much the crankshaft speeds up or slows down during that cylinder's power stroke, compared with the average of all cylinders, at idle and low speed. A cylinder that makes less torque than the others reads lower; one that makes more reads higher. It is a quick way to see whether the cylinders are balanced.
Open Tune → Ignition → Spark trim.
In the example, cylinder 5 is retarded by 1° and cylinder 2 by 0.5°, and cylinder 3 is advanced by 0.5°.
Knock in one cylinder. If knock control shows one cylinder knocking first, retard just that cylinder by 1–2° rather than the whole engine. The others keep their timing and their power. See Knock control.
Balancing a rough idle. At idle, watch the RPM offset. If one cylinder reads clearly lower than the others, first check it is not a mechanical or fuel problem (a leaking valve, a weak coil, a dirty injector). If the engine is healthy, a little advance on the weak cylinder, or retard on the strong one, can smooth the idle. Change one cylinder at a time, by 0.5–1°.
Different cylinder temperatures. On engines whose end cylinders run cooler, the middle cylinders may knock first at full load: they can carry a little less timing than the end ones.
Keep trims small, usually within ±2°. A cylinder that needs much more is telling you about a fault: look at its fuel, its compression and its ignition.
Yes: each cylinder has one trim, added wherever the engine runs. To change the timing by speed and load, use the ignition table; use spark trim for the differences between cylinders.
Yes. Knock control pulls timing on top of the trims, from every cylinder, as usual.
Contact customer support at [email protected].
Related pages: Ignition table · Knock control · Engine configuration · Ignition coil dwell