An alternator is a constant drain on the engine: charging hard at full throttle can cost several horsepower, and an alternator that charges the same way all the time wastes fuel at cruise. With an alternator whose regulator takes a control signal from the ECU, the RM-Primis can set the charging voltage itself: lower at full throttle so all the power goes to the wheels, higher on the overrun when charging is free, and steady at idle.
This page explains how alternator control works and how to set a sensible charging strategy.
Like boost and VVT control, the alternator control works in one of two ways:
| Mode | What the table holds |
|---|---|
| Open loop | The control output's duty in %, by engine speed and load |
| Closed loop | The target voltage, by engine speed and load. The ECU compares the measured voltage with the target and a PID adjusts the output to hold it |
Closed loop holds the voltage whatever the electrical load: headlights, fans and the fuel pump switching on and off.
Open I/O → Alternator, with Overview, Target voltage and PID.
| Setting | What it does |
|---|---|
| Enable | Switches alternator control on |
| Closed loop (hold the target voltage) | Off: the table is the output duty. On: the table is the target voltage the ECU holds |
| Activate only while running | Holds the output off while the engine is not running |
| Output pin | The output wired to the alternator regulator's control input |
| PWM frequency | The control signal's frequency: use the alternator maker's figure |
| Invert output | Reverses the control signal |
The example charging strategy, by load (down) and engine speed (across):
Keep every cell within what the battery is happy with: around 13.0 V to 14.8 V for a lead-acid battery; check the maker's figures for lithium or AGM batteries.
In closed loop the PID page holds the controller (P, I, D, Gain, Loop speed), its Output limits and the live values: load, feedback voltage, target and output. Tune it as any other PID in RM-Tuner: raise the gain until the voltage starts to hunt, then back it off, and use Trend PID to watch the voltage follow the target. See Boost control for how P, I and D act.
If the alternator control fails, the battery is no longer charged correctly. Watch the battery voltage on the dashboard, and add a programmable output warning lamp for low voltage. See Programmable outputs.
No: only alternators whose regulator takes a control signal from the engine ECU. A conventional alternator with its own internal regulator charges by itself and needs no ECU control.
At a lower voltage the alternator draws less current and needs less torque to turn, so a little more of the engine's power reaches the wheels.
Contact customer support at [email protected].
Related pages: Generic PWM outputs · Programmable outputs · Boost control