The RM-Primis ECU reads the throttle position from the throttle position sensor (TPS), a voltage that rises as the throttle opens. The calibration table turns that voltage into a throttle opening from 0 % (closed) to 100 % (fully open). Alpha-N fuelling, acceleration enrichment, idle control, flood clear and launch control all use it.
How the sensor works. A TPS is a potentiometer on the throttle spindle, fed with 5 V: as the throttle opens, the wiper moves along a track and the voltage rises, typically from about 0.5 V closed to 4.5 V fully open. No two throttle bodies give exactly the same voltages, which is why the ECU learns your closed and open readings rather than assuming them. The calibration matters more than it looks: the acceleration enrichment reacts to how fast the reading changes, and the idle control watches it to know when your foot is off the pedal, so a TPS that reads 3 % at rest can upset both.
Open Setup → Sensors → Throttle position.
| Setting | What it does |
|---|---|
| Table | The throttle opening at each sensor voltage |
| Enable TPS Sensor | Switches the sensor on |
| Input select | The ECU input the sensor is wired to: TPS, or a spare input |
| Quick cal | Fills the table in a straight line between two points: the closed and the fully open voltage |
| Calibrate ETB | With an electronic throttle, calibrates through the throttle module |
| Alarm limits: Max. / Min. Value | The voltage range a working sensor stays inside; outside it the ECU stores a fault code |
| Live values | Voltage and TPS 0-100% now |
Calibrate again after adjusting the throttle stop or the idle screw, or changing the sensor or the throttle body.
The throttle position is used in more places than it looks, and a small error shows up in all of them:
| Where | What the throttle position decides |
|---|---|
| Alpha-N fuelling | It is the engine load: the fuel and ignition tables are read by it |
| Acceleration enrichment | How fast it changes (TPS change/s) is what triggers the extra fuel on a tip-in |
| Idle control | Below or pedal below, idle counts as requested and the closed loop runs |
| Overrun fuel cut | The fuel is cut only below Pedal less than |
| Launch control | Works only above TPS Threshold |
| Boost and anti-lag tables | Read by throttle position, so the boost follows the driver's foot |
| Flood clear | Full throttle while cranking cuts the fuel to clear a flooded engine |
A worked example. A throttle body whose closed reading has drifted up by 0.1 V reads about 2.5 % at idle. That is above a 2 % or pedal below, so the idle closed loop never runs and the engine hunts; and above a 0.25 % Pedal less than, so the overrun fuel cut never happens. One recalibration fixes both.
Checking a worn sensor. A TPS track wears where the throttle spends most of its life, usually just off idle. With the engine stopped, open the throttle very slowly from closed to full and back while watching TPS 0-100%, or log it: the reading must rise and fall smoothly. A sudden jump or a drop to 0 for a moment is a dead spot. On the road it shows as random acceleration enrichment (a spike in TPS change/s with the foot steady) and a stumble at a steady throttle: replace the sensor.
The throttle is resting slightly open, or the calibration was done with the throttle not fully closed. Close the throttle fully and calibrate again.
The voltage left the Alarm limits: check the sensor's 5 V supply, ground and signal wire, and that the limits are not too tight.
Contact customer support at [email protected].
Related pages: Acceleration enrichment · Electronic throttle · Fuelling settings · MAP sensor