The RM-Primis ECU switches the fuel pump on when the ignition is turned on, to build fuel pressure before you crank, and switches it off soon after the engine stops, so a stall or an accident does not leave the pump running. It can drive the pump through a relay, at variable speed by PWM, or through BMW's own CAN fuel pump modules.
Why run the pump at variable speed? A pump sized for full power moves far more fuel than an idling engine uses. With a return-type system the surplus goes back to the tank, carrying heat with it; the pump draws full current and makes its full noise all the time. Running it slower when the engine needs little fuel keeps the fuel cooler, the pump quieter and longer-lived, and the electrical load lower. The pump must still deliver enough at full load: check the fuel pressure holds when you set it up.
Open Setup → Engine → Fuel pump.
| Setting | What it does |
|---|---|
| Fuel pump | Switch on for the ECU to control the fuel pump |
| Pressurise timeout | How long the pump runs when the ignition is switched on, to build rail pressure before cranking. 2–3 s is usual |
| Engine stop timeout | How long the pump keeps running after the engine stops turning. Keep it short (about 1 s), so the pump stops soon after a stall |
| Control type | ON/OFF: a relay switches the pump on and off. GP PWM 1–4: the pump runs at variable speed from one of the generic PWM outputs; set that output up first. A PWM pump needs a suitable pump driver module for its current |
| CAN bus Fuel Pump Module | For BMW cars with a fuel pump module controlled over CAN: BMW E85/83/86, BMW E81/82/87 & E9x or BMW F-series. The E85, E83 and E86 modules are on and off only; the others can also run in closed loop by setting Control type to PWM, with no output to choose |
If the engine is slow to start after standing, check the fuel pressure builds within Pressurise timeout; raise it a little if it does not. Never bypass the ECU's control of the fuel pump: it is what stops the pump after a stall or an accident.
The ECU's fuel calculation assumes the injectors always see the same fuel pressure across them. Every fuel table, dead time and injector size in the tune is only right at that pressure:
Sizing the pump. A petrol engine burns roughly 0.45–0.55 lb of fuel per horsepower per hour at full load (more on E85, about 30–40 % more). Choose a pump that delivers that flow, plus a margin of 20–30 %, at the pressure and voltage it will really run at, not its free-flow figure.
Checking it. Log the fuel pressure (with a sensor on an analog input, see Analog inputs) through a full-load pull at the highest boost and engine speed. It must stay at its set pressure (above the manifold pressure, for a manifold-referenced regulator) all the way to the rev limit. A pressure that sags at the top of a pull is a pump, wiring or filter problem, not a tuning one.
Running a PWM pump. With Control type set to a generic PWM output, the pump's speed comes from that output's table: slow at idle and cruise, full speed well before the engine needs it. Keep the duty at 100 % from well below full load and boost, and check the pressure in a log at every point where the duty changes. See Generic PWM outputs.
Long enough for the fuel pressure to reach its working value with the ignition on: usually 2–3 seconds. Check it with a fuel pressure gauge.
Yes. Choose your car's module under CAN bus Fuel Pump Module.
Contact customer support at [email protected].
Related pages: Fuelling settings · Engine configuration · Wiring diagram