RM-Tuner updates the RM-Primis ECU's firmware over the same USB connection you tune with. When you connect, RM-Tuner checks for a newer firmware and offers to update; you can also update by hand at any time from the Firmware update page. If an update is interrupted, the same page recovers the ECU.
Update with the engine off, a battery charger on the car, and the laptop on mains power. Never disconnect the USB cable or switch the ignition off while the firmware is being written.
Open Diag → Diagnostics & tools → Firmware update. When RM-Tuner offers a new firmware on connecting and you accept, it brings you here.
Save your tune with File → Save before you update. After updating, check the ECU reports the new version at the bottom right of RM-Tuner, and that your tune is as you left it.
If an update was interrupted (the cable came out, the laptop's battery ran out) and the ECU no longer runs, don't panic: the ECU keeps its bootloader, and the update can be done again.
RM-Tuner notices when a new version of itself is available and offers to install it. Help → Check for updates… asks at any time. See Download RM-Tuner.
Yes: always keep a saved copy of your tune (File → Save) before updating the firmware, so you can load it again if anything goes wrong.
Follow Recovering an ECU above: find the bootloader and write the firmware again.
Contact customer support at [email protected].
Related pages: Download RM-Tuner · Getting started